Home > DOCUMENTUM > Prerequisites ,Installation and Configuration of ACS

Prerequisites ,Installation and Configuration of ACS

November 10, 2010

In my previous post i tried to bring out what is ACS , today lets see how we can install and configure an ACS , to start off with the Prerequisites for ACS:

a) Content Server.

b) Global registry Repository.

Installation and configuration of ACS:

Administrator doesn’t need to install it explicitly; it gets installed automatically when Content server 5.3 sp1 and above are installed. An ACS config. Object is also created automatically in the menu:

Administration-> Configuration->ACS Servers. As shown in following diagram:

 

The Administrator can check whether this service is running or not by going to following link in his system http://[system ip address]: [port no]/ACS/servlet/ACS. Or he can see the ACS service running in the services of his operating system service manager.

The Configuration of ACS means configuration of ACS server for the repository which will serve by that ACS server to specified network locations. We need to configure the ACS server config. Object for each repository, irrespective of the content server under which it is created. This configurations will be as following:

1)    Go to the Servers in Administration->configuration->Servers and click on information button to edit the properties for that server config. Object.

Go to “Connection Broker Proj” Tab and add the address of host name on which the ACS server is installed and also specify the Proximity for that Server. Administrator can add more than one connection broker to one repository at any time.

Now after following the above steps , you will see that the ACS server got added to server config object:

2)    Go to the “Network Location Proj “ tab to add the network location to be served by the repository.

Network Location got added to Server Config Object as in below:

3)    Now save and come out of the server config object to the ACS server config Object. And verify the “Connection Broker Projection” and “Network Location projection” for correct entries.

Now the ACS server is configured to the Repository server through a Connection broker to serve a set of network location.

Note: While creating the connection broker object take care for false host name because the Documentum never verifies for fake/non existing hosts.

%d bloggers like this: